What Is The Procedure For Removing And Installing Curtain Wall Glass?

The removal of broken curtain wall glass and curtain wall glass removal is a very technically difficult task in glass replacement construction. In addition to fully understanding the structure of the original curtain wall, you must also have rich work experience. Because once the original curtain wall glass is broken, if you are not careful, the broken glass fragments may fall and damage the glass in other parts. Especially if the glass area is too large, it will be more difficult to remove the curtain wall glass.

1. To remove the original glass, use tape on the surface of the easily broken glass to ensure that the glass fragments will not fall. Gently push the broken glass away from all sides, and use a suction cup to remove the original broken glass as a whole and put it away. Go to the safety bucket, clean up the debris around the glass, use a wallpaper knife to remove the sealant around the glass, take out the foam rod from the glue joint, use a hexagonal wrench to remove the aluminum alloy glass fixings from the glue joint, and the four construction workers outside Use suction cups to suck on the glass. The three people inside also use suction cups to suck on the glass. They lift the inside and outside at the same time. The top of the glass faces outwards and the bottom faces into the room. Slowly slide down until it lands safely. The people inside hold on with their hands. Glass, people from outside came in through the window and safely transported the glass to the second underground floor.
2. Remove the aluminum alloy frame of the broken glass and use two-component glass structural glue to bond the glass and aluminum alloy frame together. The curing time of the glass structural glue is 2 hours. After the glass structural glue is cured, clean the glass surface. Transport safely to the construction site.
3. When installing the glass, the outside construction workers go to the roof and follow the rope slide to the construction position, with the top of the glass facing outward. The inside and outside construction workers suck up the suction cups, and the inside and outside work together to lift them. The top side of the glass goes out first, followed by the bottom side. , lift up, slide to the left, hang the glass aluminum alloy frame hook, use a hexagonal wrench to tighten the aluminum alloy fixings, fill the glue seams around the glass with foam rods, paste the glue seams with textured paper, and use a glass glue gun to seal the glass Apply glue into the glue joints, use a gray knife to compact the glue joints, make the glue joints around the glass smooth and smooth, clean the glass surface, the outside construction workers slide along the rope to the first floor, go up to the roof and put away the rope, and the inside construction workers finish the work Clean the house, restore the current condition of the house, take out the cleaned garbage, and inspect the construction site with the person in charge of Party A to ensure that there are no residues or problems with the project.