How To Cut Square Tube 45 Degrees?

The square tube should be cut at a 45-degree angle. The calculation method is to cut a 500 mm square tube at a 45-degree angle. You can measure 50 cm on the length of the square tube, draw a line on the square tube, and draw a circle, draw a diagonal line, Then draw a diagonal line on the opposite side of the diagonal line, and the direction of the two diagonal lines should be the same. Cut along the diagonal, which is a 45-degree angle of square tube.

Mobile/Whatsapp: +8618222029592 

1. The cutting start position is the position of the side length of the square tube, and the end point is the edge of the square tube.

2. When the cutting is at 45 degrees, the cutting line is exactly the diagonal of a square with the side length of the square tube as the side. At this time, the starting position of cutting is the position point of the side length of the square tube, along the diagonal direction Cut to get a 45 degree bevel cut.

3. Most of the square tubes are mostly steel tubes, which are unpacked, flattened, crimped, welded to form a round tube, and then rolled into a square tube from the round tube and then cut to the required length.

4. The ability of metal materials to resist damage (excessive plastic deformation or fracture) under static load. Since the load acts in the form of tension, compression, bending, shearing, etc., the strength is also divided into tensile strength, compressive strength, flexural strength, and shear strength. There is often a certain relationship between various strengths, and tensile strength is generally used as the most basic strength indicator in use.